Icom F2000D UHF Two-Way Radio (Discontinued)

Description Compact, Waterproof Digital Business Radio While the body is compact, the IC-F2000D has rugged construction, providing superior protection against water (1m depth for 30 minutes), dust, sand, mud and other objects. The radio is also tested on MIL-STD 810 specifications. It can withstand harsh use. The IC-F2000D can program Type-D single-site trunking, digital conventional modes, and analogue mode per channel. The IDAS digital mode employs 4-level FSK modulation and the NXDN™ common air interface, offering true 6.25kHz spectrum efficiency, higher security and better audio clarity–even at the fringes of the communication range. What’s In The Box? The F2000D comes standard with all of the items listed below: F2000D Radio Antenna (FA-SC55V, FA-SC57U or FA-SC72U) Battery (BP-280) Belt Clip (MB-133) Owner’s Manual 2 Year Warranty The F2000D is a UHF Radio UFH stands for Ultra High Frequency. UHF radios have a higher frequency than VHF radios, which is Very High Frequency. UHF radios have a shorter wavelength, allowing them to travel through obstacles more easily. This makes them ideal for indoor use. VHF radios’ longer wavelength allows them to communicate further in an environment with few obstacles, making them ideal for outdoor use. If you are adding new radios to an existing fleet of radios, it is essential to order the same type of radio. This UHF F2000D radio cannot communicate with the identical-looking VHF F1000D. Check the model number on the back of the radio, covered by the battery, to ensure you are ordering the correct radio. If you have any questions, please call us at 1-800-396-1911. The F2000D Radio Features: Intelligent Emergency Functions The IC-F2000D has three emergency-related functions to assist in worker safety: motion detection, man down and lone worker functions. If one of these functions is activated, the transceiver automatically enters an emergency phase and starts counting down to send an emergency signal. The built-in motion sensor detects its position and state’s motion and non-motion. Slim, Compact and Lightweight The IC-F2000D has a compact 52.2×111.8×30.3mm body and weighs only 260g (with BP-280 battery pack and belt clip). It’s easy to carry around anywhere. Optional GPS Speaker-Microphone With the optional GPS speaker-microphone, HM-171GPW, GPS position data can be attached to a voice or data transmission, such as responding to a GPS request status call. Easy to Hear in a Noisy Environment The large 36mm speaker of the transceiver provides clear 800mW* audio. The built-in BTL amplifier increases the audio output power and delivers loud and intelligible voice to a radio operator in noisy environments. *Typical with internal speaker. Built-in 2-Tone and 5-Tone (Analog mode) The IC-F2000D has built-in 2-Tone, 5-Tone, CTCSS and DTCS signalling capability for analogue mode group communication and selective calling. The IC-F2000D can be used as an analogue transceiver ready for future digital migration. Long-Lasting Battery Pack The large capacity waterproof battery pack, BP-280 (2400mAh typ.), provides 18 hours of operating time*. The supplied rapid charger BC-213* charges the BP-280 in 3.5 hours. *Tx: Rx: Standby=5:5:90. Power save function ON. BC-213 may not be supplied depending on the version. Specifications: Other Features: DTMF autodial memories MDC 1200 functions: PTT ID, emergency call, radio check (RX) and stun/revive (RX) Surveillance function Escalating alarm VOX capability for hands-free operation Channel announcement function Red emergency switch on the top panel The Following IDAS Features Are Programmable: PTT ID (TX) Individual/group calls Radio check (RX) Stun/Kill/Revive (RX) Remote monitor (RX) Emergency (TX) Call Alert (RX) Digital voice scrambler (15-bit) Status Call (Power ON/OFF status and GPS request) Voting scan for multi-site conventional operation TX: Transmit, RX: Receive